protocol-address De?¬?nes the network layer address of the destination router interface.
dlci De?¬?nes the local DLCI that is used to connect to the remote protocol
address.
broadcast (Optional) Allows broadcasts and multicasts over the VC. This
permits the use of dynamic routing protocols over the VC.
ietf | cisco Enables IETF or Cisco encapsulations.
payload-compress
packet-by-packet
(Optional) Enables packet-by-packet payload compression, using the
Stacker method. This is a Cisco-proprietary compression method.
Establishing a WAN Connection with Frame Relay 337
Figure 8-29 Point-to-Point Subinterfaces
Follow these steps to con?¬?gure subinterfaces on a physical interface:
Step 1 Select the interface upon which you want to create subinterfaces and enter
interface con?¬?guration mode.
Step 2 Remove any network layer address that is assigned to the physical
interface and assign the network layer address to the subinterface.
Step 3 Con?¬?gure Frame Relay encapsulation.
Step 4 Use the following command to select the subinterface you want to
con?¬?gure and to designate it as a point-to-point subinterface:
RouterX(config-if)# iinntteerrffaaccee sseerriiaall number.
Pages:
479
480
481
482
483
484
485
486
487
488
489
490
491
492
493
494
495
496
497
498
499
500
501
502
503