RouterX(config-if)# ffrraammee--rreellaayy llmmii--ttyyppee {aannssii | cciissccoo | qq993333aa}
This command is needed only if you are using Cisco IOS Software Release 11.1
or earlier. With Cisco IOS Software Release 11.2 or later, the LMI type is
autosensed and no con?¬?guration is needed. The option cisco is the default. The
LMI type is set on a per-interface basis and is shown in the output of the show
interfaces EXEC command.
Step 5 Con?¬?gure the bandwidth for the link using the bandwidth [kilobits]
interface con?¬?guration command. For example:
RouterX(config-if)# bbaannddwwiiddtthh 6644
This command affects routing operations performed by protocols such as
Enhanced Interior Gateway Routing Protocol (EIGRP) and Open Shortest Path
First (OSPF), as well as other calculations.
Step 6 Enable Inverse ARP if it was disabled on the router. Use the frame-relay
inverse-arp [protocol] [dlci] interface con?¬?guration command.
The protocol parameter indicates the protocol in use. Supported protocols include
IP, Internetwork Packet Exchange (IPX), AppleTalk, DECnet, Banyan Virtual
Integrated Network Service (VINES), and Xerox Network Services (XNS).
Pages:
476
477
478
479
480
481
482
483
484
485
486
487
488
489
490
491
492
493
494
495
496
497
498
499
500