Figure 8-20 PPP & CHAP Con?¬?guration Example
Example: Verifying PPP Encapsulation Configuration
Use the show interface command to verify proper con?¬?guration. Example 8-1 shows that
PPP encapsulation has been con?¬?gured and LCP has established a connection, as indicated
by ???LCP Open??? in the command output.
Example 8-1 Verifying PPP Encapsulation with the show interface Command
RouterX# sshhooww iinntteerrffaaccee ss00
Serial0 is up, line protocol is up
Hardware is HD64570
Internet address is 10.140.1.2/24
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation PPP, loopback not set, keepalive set (10 sec)
LCP Open
Open: IPCP, CDPCP
Last input 00:00:05, output 00:00:05, output hang never
Last clearing of ???show interface??? counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
38021 packets input, 5656110 bytes, 0 no buffer
Received 23488 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
38097 packets output, 2135697 bytes, 0 underruns
0 output errors, 0 collisions, 6045 interface resets
RouterX RouterY
hostname RouterX
username RouterY password sameone
!
int serial 0
ip address 10.
Pages:
456
457
458
459
460
461
462
463
464
465
466
467
468
469
470
471
472
473
474
475
476
477
478
479
480