RouterX(config)# iipp nnaatt ppooooll name start-ip end-ip {nneettmmaasskk netmask |
prefix-length prefix-length}
Enter the no ip nat pool global command to remove the pool of global addresses.
Step 2 De?¬?ne a standard access control list (ACL) that permits the addresses
that are to be translated.
RouterX(config)# aacccceessss--lliisstt access-list-number ppeerrmmiitt source [ sourcewildcard]
Enter the no access-list access-list-number global command to remove the ACL.
Step 3 Establish dynamic source translation, specifying the ACL that was
de?¬?ned in the prior step.
RouterX(config)# iipp nnaatt iinnssiiddee ssoouurrccee lliisstt access-list-number ppooooll name
Enter the no ip nat inside source global command to remove the dynamic source
translation.
Step 4 Specify the inside interface.
RouterX(config)# iinntteerrffaaccee type number
After you enter the interface command, the CLI prompt changes from (con?¬?g)#
to (con?¬?g-if)#.
Step 5 Mark the interface as connected to the inside.
RouterX(config-if)# iipp nnaatt iinnssiiddee
Step 6 Specify the outside interface.
RouterX(config-if)# iinntteerrffaaccee type number
10.1.1.2
E0
10.
Pages:
363
364
365
366
367
368
369
370
371
372
373
374
375
376
377
378
379
380
381
382
383
384
385
386
387