RouterX(config-if)# iinntteerrffaaccee type number
Step 5 Mark the interface as connected to the outside.
RouterX(config-if)# iipp nnaatt oouuttssiiddee
Use the command show ip nat translations in EXEC mode to display active translation
information, as demonstrated here:
RouterX# sshhooww iipp nnaatt ttrraannssllaattiioonnss
Pro Inside global Inside local Outside local Outside global
--- 192.168.1.2 10.1.1.2
9. Perform NAT inside to outside (local to
global translation).
10. Check crypto map and mark for
encryption if appropriate.
11. Check outbound access list.
10. Check crypto map and mark for
encryption if appropriate.
11. Check outbound access list.
12. Inspect CBAC.
13. Intercept TCP.
14. Perform encryption.
15. Perform queuing.
Table 7-1 Router Processing Order (Continued)
Local-to-Global Global-to-Local
256 Chapter 7: Managing Address Spaces with NAT and IPv6
Static NAT Address Mapping
The example shows the use of discrete address mapping with static NAT translations for
the network in Figure 7-4. The router translates packets from host 10.1.1.2 to a source
address of 192.168.1.2.
Figure 7-4 Static NAT Address Mapping
To con?¬?gure dynamic inside source address translation, follow these steps:
Step 1 De?¬?ne a pool of global addresses to be allocated as needed.
Pages:
362
363
364
365
366
367
368
369
370
371
372
373
374
375
376
377
378
379
380
381
382
383
384
385
386